QMS 2425 Specifications download pdf (Page 129)

&RQWURO3DQHO

3UREOHPV

7URXEOHVKRRWLQJ3ULQWHU3UREOHPV

&RQWURO3DQHO3UREOHPV

'D WD,QGLFDWRU6WD \V/LW

If the printer has warmed up and the Data indicator stays on, two

problems may exist:

 If you are downloading additional typefaces, too many can over-

load the printer’s memory, causing the printer to reset and lose

information previously downloaded to RAM. Make sure you have

enough printer memory.

 On a LocalTalk network, Macintosh computers sometimes inter-

fere with each other. If this happens often, reinstall the Laser-

Writer and Laser Prep files, which reset the printer. If neither of

these is the problem, place a service call to your QMS vendor.

1R$G YDQFHG6W DWXV 3DJH¶

If your printer prints a standard status page even though you’ve con-

figured the printer in the Administration/Special Pages/Status Page

Type menu to print an advanced status page, your printer probably

doesn’t have enough free memory available. To print an advanced

status page you may need to reduce the amount of memory assigned

to one or more of the memory clients or add more memory (see the

“Memory” section in chapter 5, “Additional Technical Information,” of

the

Reference

guide for information about memory clients).

1R6WDUWXS3DJH

If the Ready indicator is on, but no start-up page prints, check the fol-

lowing:

1 Has the start-up page been disabled?

Use the control panel to make sure the start-up page is on.

1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 185 186

No comments

QMS 2425 Specifications Page 129