QMS Magicolor WX User's Guide Page 160
- Page / 248
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
Cleaning the
Printer
QMS magicolor WX User's Guide5-34
Cleaning the Rollers
1 Turn off the printer and remove the power cord.
2 Open the manual feed tray by lightly pressing on the top-
right corner, and then tilt the tray out and down.
▲ Caution:
The OPC belt is extremely sensitive to bright lights and
direct sunlight. Limit exposure to 800 lux (the average fluorescent
lighting in an office) of light to under 2 minutes. If exposure
exceeds this, put the belt in a dark place to recover; depending on
exposure, recovery may take up to 2 hours.
Also, handle the OPC belt carefully, using either the two green
side-handles or using the green end-handle when possible. It is
extremely sensitive to hand oils and scratches both of which
reduce print quality. When you must set it down, gently lay it on a
clean, lint- and dirt-free surface, such as on fresh paper for the
printer.
3 Lift the OPC belt cartridge handle up to unlock it, and pull
the cartridge straight out of the printer.
- User's Guide 1
- Trademarks 2
- Proprietary Statement 2
- Copyright Notice 2
- Manual Notice 2
- Typographic Conventions 3
- Contents 5
- 2 Printing 6
- 3 Control Panel 7
- 4 Printer Options 7
- 5 Maintenance 8
- 6 Repacking the Printer 8
- 7 Troubleshooting 9
- A QMS Customer Support 9
- B Technical Specifications 10
- In This Chapter . . 11
- Introduction 12
- Find a Good Location 12
- 16"/40 cm 13
- 4"/10 cm 13
- 36"/90 cm 13
- 28"/70 cm 13
- Unpack the Printer 14
- Strap Handles 15
- Front View 15
- Packing 15
- Check Shipment Contents 16
- Set up the Printer 17
- Toner Cartridge 20
- Cleaning 24
- Oil Bottle 24
- Install the Waste Toner Pack 28
- TabRear View 29
- Release 31
- Unlock the 32
- Light-Shield 33
- Fill the Paper Cassette 34
- Install the Printer Driver 36
- Register the Printer 39
- Printing 41
- Configuring the Windows 95 42
- Print Job 43
- Configuring Paper Options 44
- Paper Size 45
- Orientation 45
- Paper Source 46
- Media Choice 46
- Copy Count 47
- About... Button 47
- Restore Defaults Button 47
- Apply and OK Buttons 47
- Cancel Button 47
- Configuring Graphics Options 48
- Resolution 49
- Dithering 50
- Intensity 50
- Color... Button 50
- Configuring Color Options 51
- Color Control 52
- Color Rendering Intent 52
- OK Button 53
- Configuring the Windows NT 54
- 4.0 Printer Driver 54
- Windows NT 4.0 Start Menu 55
- Application 55
- Configuring the 57
- Windows NT 4.0 57
- Color Appearance 59
- Configuring Advanced Options 60
- Halftone Color Adjustment 64
- Metafile Spooling 65
- Contrast 67
- Brightness 67
- Dark Picture 68
- Negative 68
- Black Ref. and White Ref 68
- Illuminant 69
- Input RGB Gamma 69
- Picture Check Boxes 71
- Default Button 71
- Revert Button 71
- Configuring Device Settings 72
- Halftone Setup 75
- Halftone Pattern 76
- Device Gamma 76
- Pixel Diameter 76
- Printing on a Network 80
- NT 4.0 Users 81
- 4.0 as illustrated below 83
- Refilling the Media Cassette 84
- EX LT A4 LG 85
- Using the Manual Feed Tray 87
- Print Media 89
- More About Print Media 91
- More About 92
- Recommended Brands 94
- Print Media Storage 94
- Preventing Media Jams 95
- Cancelling a Print Job 96
- About the Control Panel 99
- About the 100
- Control Panel 100
- The Function Keys 101
- Printer Configuration 102
- The Configuration Menu 103
- Setting Energy Conservation 106
- Setting the Media Source 106
- Printer Options 107
- Available Options and 108
- Accessories 108
- Sheet Feeder 108
- The Envelope Cassette 112
- Set the 113
- Side Stackers 113
- Stacker Arm 113
- Rear Stacker 113
- Flap Side 114
- Removing and Replacing the 116
- Controller Board 116
- Single In-Line Memory 119
- Modules (SIMMs) 119
- Updating System Software 122
- Updating the Windows 95 123
- Printer Driver 123
- Updating the Windows NT 4.0 125
- Maintenance 127
- Preventive Maintenance 128
- About Consumables 129
- Ordering Consumables 130
- Storing Consumables 130
- Replacing Consumables 131
- Save the protective bag 142
- Cleaning the Printer 151
- Unit, and the AC-Charger Unit 152
- Cleaning the Rollers 160
- Sie den Drucker reinigen 167
- Repacking the 169
- Remove Cables and Cassette(s) 170
- Remove the Toner and 171
- Developer Cartridges 171
- Rear View 172
- Replace the Fuser-Roller 175
- Pressure-Release Pieces 175
- Remove the OPC Belt 178
- Cartridge 178
- Pressure 179
- Release Pin 179
- Tension-Release 179
- Remove the Waste Toner Pack 180
- Repack the Printer 180
- Troubleshooting 185
- Miscellaneous Problems 186
- Blank Pages 187
- Only a Partial Page Prints 187
- Not All Pages Print 188
- Print Quality Problems 188
- Changing Print Density 194
- Printer Status Messages 195
- Printer Status 196
- Messages 196
- Clearing Status Messages 200
- Service Call Messages 201
- Clearing Media Jams 202
- Clearing Inner Jams 205
- Clearing Outer Jams 211
- Clearing Media 213
- 3 Open the paper exit unit 213
- ▲ Caution: 214
- Reseating the Drum 216
- Manually 218
- Placing a Service Call 220
- QMS Customer 221
- Sources of Support 222
- CompuServe 223
- Internet 223
- QMS World-wide Offices 225
- QMS EMEA 226
- QMS Spain 227
- Specifications 229
- Technical 229
- Print Engine Specifications 230
- Controller Specifications 231
- Environmental Requirements 231
- Print Media and Consumables 232
- Centronics Parallel Cable 232
- Energy Star Compliance 234
- FCC Statement 234
- Laser Safety 235
- Canadian Users Notice 235
- International Notice 236
- Warranty Considerations 236
Related products and manuals for Laser/LED printers QMS Magicolor WX
Laser/LED printers QMS 2425 User's Guide
(144 pages)
(144 pages)
Laser/LED printers QMS ImageServer User's Guide
(328 pages)
(328 pages)
Laser/LED printers QMS 1060 Specifications
(110 pages)
(110 pages)
© 2020, manymanuals.com. All rights reserved. | 0.415 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals