QMS 4060 Technical Information download pdf (Page 165)

End Job Mode

5-23

Additional Technical Information

Stand-Alone PC

1 Set the end job mode from the printer's control panel.

2 Add the EOD command to your file.

» Note:

If using steps 1 and 2 is not feasible in your stand-alone PC

environment, you can alternatively use a program that either

causes an emulation timeout or that inserts an EOD command

between each print job. See your QMS vendor for more

information on this type of program.

PC Print Server

1 Set the end job mode from the printer’s control panel.

2 Create a job separator to append an EOD command and

send it between each print job.

Other Print Queuing Systems

If you use a print queuing system other than a PC print server and

you experience what appears to be an EOD command problem, you

may need to use another procedure, such as a print utility, an initial-

ization sequence, or a header page to add an EOD command. See

your print queuing system documentation, your network administra-

tor, or your QMS vendor for more information.

Setting the End Job Mode via the Control

Panel

Use the following procedure to set the end job mode from the printer’s

control panel for printers connected via the optional serial or parallel

interface to a stand-alone PC, a PC print server, or some other type of

print queuing system.

» Note:

If you print both serial and parallel protocol jobs, then you must

set the end job mode for each protocol.

Wait for the printer to go idle, and then press the control panel buttons

in the order shown in the following instructions to access the End Job

Mode option. The printer responds by displaying a status message in

the message window.

1 2 ... 160 161 162 163 164 165 166 167 168 169 170 ... 231 232

No comments

QMS 4060 Technical Information Page 165