QMS 4032 Specifications download pdf (Page 48)

#





This menu contains several options that allow you to configure the printers communi-

cation parameters to match the host and application parameters.

»Note:

This section contains information on the Timeouts, Parallel, and Resident NIC

menus. For information on printer-host communication using the Ethernet interface or

any options located under the CrownNet submenu (Administration/Communications/

Resident NIC/CrownNet), see chapter 2, “Printer Configuration,” of the QMS

CrownNet System Administrator’s Guide



For information on the optional serial and

LocalTalk interfaces, see the Options manual.

"#

The Timeouts options limit the amount of time the printer waits on transmission from

the host for various types of data.

# #

The PostScript emulation timeout is the maximum number of seconds the PostScript

emulation waits for incoming data.

Administration/Communications/Timeouts/PS Wait Timeout

Choices

00000-99999

Default

00030 (30 sec.)

Notes

A value of 00000 is the same as infinity (no timeout).

The job is closed and the next job in the queue begins if all of the

following occur:



No additional data is received during the specified period of time.



The interface didn’t time out.



An EOD (end-of-document commands) was not seen.

When a print job is sent from a Macintosh, the PS Wait timeout is

automatically changed to 00300 (5 min.).

Large print jobs, such as those generated by graphics or computer-aided

design applications, require timeouts of 00300 (5 min.).

EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 233 234

No comments

QMS 4032 Specifications Page 48